Technical requirements for intelligent installation of photovoltaic panels

Are there any UK standards relating to a PV installation?

While many UK standards apply in general terms, at the time of writing there is still relatively little which specifically relates to a PV installation. However, there are two documents which specifically relate to the installation of these systems that are of particular relevance:

What are the requirements for a PV installation?

Virtually all domestic PV installations will fall under the scope of Part P. Part P requires the relevant Building Control department to be notified and approve the work. There are two routes to comply with the requirements of Part P: Notify the relevant Building Control department before starting the work.

Are PV systems compatible with the utility grid?

Interest in PV systems is increasing and the installation of large PV systems or large groups of PV systems that are interactive with the utility grid is accelerating, so the compatibility of higher levels of distributed generation needs to be ensured and the grid infrastructure protected.

How should a PV system be designed & installed?

From the outset, the designer and installer of a PV system must consider the potential hazards carefully, and systematically devise methods to minimise the risks. This will include both mitigating potential hazards present during and after the installation phase.

Are all PV products covered by IEC61730 'photovoltaic (PV) module safety qualification?

In future it is expected that all PV products will increasingly be covered by International standard IEC61730: 2004 ‘Photovoltaic (PV) module safety qualification’.

What is the minimum size requirement for a solar energy system?

Different ISOs have different minimum size requirements. Some allow systems rated at 10 MW and higher, some at 1 MW. Energy storage or PV would provide significantly faster response times than conventional generation. Systems could respond in milliseconds (once the signal is received) relative to minutes for thermal plants.